Belt+Disc Sander

From i3Detroit
Jump to: navigation, search

This page has been removed from search engines' indexes.

Belt+Disc Sander
Beltdiscsander.jpg
Name Belt+Disc Sander
Zone Wood Shop


Owner Nick Britsky
Make Model TBD
Part Number TBD
Date Acquired
Date Departed NO DATE DEPARTED
Storage Location This belt+disc sander was located on a rolling cart in the Wood Shop. It is no longer at i3 Detroit.
Authorization Required No
Status Departed
Value



Documentation
Other References * Belt+Disc sander consumables are on this list: Wood Shop Consumables


Intro

For shaping/sanding wood. A very versatile tool good for removing both large and small amounts of material depending on what grit sanding disc is on the machine. Within limits (see below), plastic and aluminum can also be sanded.

Rules

  • When sanding plastic, use the lightest possible pressure. Only do touch-up sanding, not bulk material removal. If the contact temperature gets hot enough to melt the plastic, solid plastic deposits will block the grit and the sanding disc will be ruined. Make sure to clean all traces of plastic dust from the disc when you are done. If you leave plastic dust on the disc, it can melt and ruin the disc when the next user sands wood.
  • When sanding aluminum, use the lightest possible pressure. Only do touch-up sanding, not bulk material removal. Structural aluminum alloys are harder than the adhesive used to hold the grit to the paper. This means your aluminum workpiece is capable of scraping the grit off of the paper, which ruins the disk.
  • Don't sand or leave anything wet unless you meticulously clean up afterwards, the table will rust.
  • For safe control, rest your workpiece on the table if possible. If this is not possible, hold your workpiece and rest your hands on the table (but away from the disc!). The danger is that the disc could grab your workpiece and jerk your hand onto the disc. Please be aware that any part of your hand that gets sanded will be removed, not smoothed.
  • The table should be close to the disc, but not touching the disc. If a thin workpiece gets jammed into the gap, both the workpiece and the sander could be damaged. If you must hand-hold a thin workpiece, try sanding on the side of the disk that moves upward.

Instructions

  • Let your workpiece touch the disc and have the disc do the work. If you have to use force to press your workpiece into the disc, the disc is worn out (and unsafe).

Maintenance Info

  • Periodically cleaning the sanding disc with the big natural rubber stick extends the life of the disc.
    • White plastic-sanding dust must be removed from the disc as soon as possible.
    • Solid plastic deposits cannot be removed from the disc with the big natural rubber stick; this just wastes rubber.
  • The sander takes 9" adhesive backed discs.

FAQ

ToDo



Belt+Disc Sander Nick Britsky Zone: Wood Shop https://www.i3detroit.org/wi/images/4/4f/Authorization_not_required.svg "/> https://www.i3detroit.org/wiki/Belt%2BDisc_Sander