Difference between revisions of "Plasma Cutter"

From i3Detroit
Jump to: navigation, search
m (Updated main "what it looks like" picture. Added some FAQ stuff.)
m (Added "Other Ref" section.)
Line 22: Line 22:
 
You can write the instructions here. Or maybe add a link
 
You can write the instructions here. Or maybe add a link
 
to another page or the user's manual.
 
to another page or the user's manual.
 +
 +
| OtherReferences =
 +
 +
[http://www.inkscape.org Inkscape] (with [http://www.cnc-club.ru/forum/viewtopic.php?t=35 Gcodetools] extension installed) is the primary software tool suggested to convert artwork into G-Codes.  The G-Codes (a simple text file) is then loaded into LinuxCNC which controls the machine.
  
 
| MaintenanceInfo =
 
| MaintenanceInfo =

Revision as of 11:49, 14 June 2013



Plasma Cutter

4' x 4' CNC Plasma Cutter (able to cut up to 1/2" steel / aluminum / copper / ...)

Basic Info

  • Ownership: Walter Fruge (100%)
  • Location: To the left of the welding table.
  • What it looks like:

Plasma Cutter Cutting

Manufacturer Information

  • Make/Model: ???
  • Part Number: ???

Documentation

not specified

Rules

Must be on the list of operators to actually run the machine, but anyone can request a part to be cut. This will be flushed out better once the tool chain is set up.

Instructions

You can write the instructions here. Or maybe add a link to another page or the user's manual.

Other References

Inkscape (with Gcodetools extension installed) is the primary software tool suggested to convert artwork into G-Codes. The G-Codes (a simple text file) is then loaded into LinuxCNC which controls the machine.

Maintenance

Maintenance Info is kept on this page:

Things that Need to be Done

In the final stages of being set up. Tool chain still needs to be defined.

FAQs

A list of commonly asked questions

  • What are the Consumables for the machine?
    • Torch Tips. To-Do: Need ordering and pricing info.
    • Steel Support Mesh. Over time the steel support mesh gets consumed as the torch makes cuts. A new set of support steel can be fabricated on the Plasma Cutter - which is just cool.
  • Can the Plasma Cutter be used as a pen plotter?
    • Yes, there is an attachment that allows for a spring mounted marker to be used.

Pen Plotting Option

  • Is it hard to convert the machine over to using the pen plotter option?
    • No, two hex-head screws clamp the pen attachment onto the torch head. Simply turn off the power switch on the plasma control panel and your good to go. Oh, and don't forget to set the pen height using "touch off" inside LinuxCNC. Typically, the pen height, when the pen is down, is set to zero. Then, a positive 1" height is set as the "safe height".